AV Equipment Instructions

Step-by-Step Instructions for Data Projectors

1. Insure that everything on your checklist is in your carrying case.

2. Take power cord and plug into the projector.

3. Take other end of the power cord and plug into wall outlet.

4. Take the MI-DA analog computer cable (this connects the projector to the computer or laptop), and insert into the appropriate connection on the projector.

5. Take the other end of the cable and insert into the appropriate connection into the computer or laptop.

6. Turn power on to the projector then turn on computer or laptop.

7. Once the projector is running properly, go ahead and adjust the size and focus of the picture, you are then ready to “GO”.

Step-by-Step Instructions for Laptops

8. Insure that everything on your checklist is in your carrying case.

9. Take power cord and insert into laptop in the appropriate receptacle.

10. Take other end of the power cord and plug into AC adapter.

11. Then take the cord from the AC adapter and plug into the wall outlet.

12. Take the end of the mouse cord and insert it into the proper receptacle.

NOTE

Take care not to bend the pins while inserting into the laptop or the mouse will not work properly.

13. Go ahead and turn on the laptop and give it time to boot up, once it’s done booting up you are ready to “GO”.

NOTE

While using with DATA Projector make sure the projector is turned on before turning on the laptop.

NOTE

If you are having trouble getting the VGA output from the laptop to the projector try using the FN+F3 key toggle, that should remedy the problem.

Step-by-Step Instructions for XGA Theater System

(Revised)

1 Plug in Main Power Cord to wall Outlet (Ensure Speakers are turned Off, and or Volume turned Down).

2. Start DATA Projector and let it warm up.

3. Connect LapTop to the LapTop connection from the XGA system. (Done, If just using LapTop & DATA projector) refer to step #6 when finished. (If no LapTop, skip to step #4).

4. Turn on the XGA Theater unit.

5. a: VCR Mode – Press the VCR button on the remote control and insert Tape. Adjust Volume to Desired level.

b: DVD Mode – Press the DVD button on the remote and insert Disk. Adjust Volume to Desired level.

c: PC Mode – Press the TV/PC button on the XGA Remote Control until the PC screen appears, give the XGA time to capture the signal. (If there is no signal from the PC, you may have to toggle the Fn and F3 keys on the LapTop)

6. Shut down equipment as you normally would.

7. Make sure the Speaker Power is turned off.

8. Roll up all cords and put back in there proper place.

NOTE:

Please Do Not, unplug any Connections or Cables from the Back of the XGA Theater Unit.